Description
Bring vintage Jensen character to your guitar rig with this 12″ Alnico-loaded driver, engineered for players who want their overdrive to bite. The tonal profile leans loose on the low end, pushes hard through the mids, and tops out bright — an edgy voice that thrives on grit rather than pristine cleanliness. This unit ships without the bell cover; if you need one, look up part p-a-p12n-bell to complete the setup.
At 50 watts rated power and 8 ohms impedance, this speaker is sized for club-level combos and cabinets where controlled headroom matters more than raw SPL. The Alnico magnet (29 oz.) gives it that classic compression and sag associated with earlier-generation Jensen voicings, while the 1.5″ voice coil and 70Hz-7kHz response range keep it focused on midrange-forward reproduction rather than full-range PA duty.
Weighing in at 6.6 lbs., it’s a straightforward drop-in replacement for players and techs rebuilding combo amps or open-back cabinets who want that recognizable Jensen breakup character back in the signal chain.
- Overall diameter: 12″
- Impedance: 8 Ohm
- Rated power: 50 Watts
- Overall weight: 6.6 lbs.
- Magnet: Alnico (29 oz.)
- Voice coil diameter: 1.5″
- Frequency response: 70Hz – 7kHz
- Bell cover not included
Reviews
There are no reviews yet.